氣動泵控制箱

產品用途：用于氣動輸漿泵自動控制

工作原理：每臺圓網印花機配置一臺電氣自動控制箱、通過24V直流電將信號傳給控制箱，通過電子元件將信號放大，控制各泵的電磁閥，使泵工作或停止。實現自動控制，無需人工操作。

安裝與保養

　　安裝時須立式安裝，用螺栓將泵固定牢固。每臺泵安裝一個油霧器，一個球閥，接通氣源。進漿管用鋼絲管，出漿管用橡膠管或軟管。泵的正確使用與保養可以延長使用壽命。每個班工作完畢后在清洗泵外部的同時把進漿管通入清水，開啟泵把泵內余漿打出，防止在泵內凝結。

　　經常檢查油霧器是否有機油。氣馬達的潤滑是靠壓縮空氣通過油霧器，調節油霧器進油螺釘，使進油量適當。輸送的漿料要過濾，細小的雜質會磨損泵的活塞和缸體。

　　泵的自動控制是用在非人工操作控制液面達到規定位置，液面與液位探桿接觸或分離并向電器控制箱發出信號，信號被電控線路板放大后送到電磁閥，使其開啟或關閉輸漿泵，實現自動控制，勿需人工操作。

Pneumatic pump control box

Product use: automatic control for pneumatic slurry pump

Working principle: every rotary screen printing machine is equipped with an electric automatic control box, and the signal is transmitted to the control box through 24V DC. The signal is amplified by electronic components, and the electromagnetic valve of each pump is controlled to make the pump work or stop. Automatic control is realized without manual operation.

Installation and maintenance

The installation must be installed vertically, and the pump is fixed firmly with the bolt. Each pump is equipped with an oil mist, a ball valve, and an air source. Steel pipe for intake pipe and rubber pipe or hose for pulping pipe. The correct use and maintenance of the pump can prolong the service life. After the work of each class after cleaning the pump outside the pump at the same time, the pipe into the water, open the pump to pump out the slurry, to prevent the condensation in the pump.

Check the oil mist regularly. The lubrication of the air motor depends on the compressed air through the oil mist, adjusting the oil intake screw for the oil mist, so that the oil intake is appropriate. The slurry to be conveyed should be filtered, and the small impurities will wear out the piston and cylinder of the pump.

The automatic control of pump is used in non manual operation to control the liquid level reaches the specified location, liquid level and liquid level probe contact or separation and sends a signal to the electrical control box, electric control circuit board signal is amplified to the solenoid valve, which opens or closes the transmission pump, automatic control, without manual operation.